Nostrum Performance Focus ST Ecoboost 2.0 Upgraded HPFP Kit

What sets Nostrum apart:Fully Laser Welded HPFP Construction Direct Bolt on Kit 100% dynamically tested Limited lifetime warranty  Uses Stock Low-Pressure Feed Line The 2 liter Ecoboost found in the Focus ST has a lot of potential, but is held back from making any real additional power by an inadequate factory fuel system. The Nostrum HPFP is the solution!Nostrum’s HPFP for the Ecoboost 2.0 is capable of flowing 36% more fuel than the factory fuel pump. The additional fuel flow allows you to dial in more boost earlier, resulting in a substantial increase in low end torque. Being that our pumps are ethanol compatible, you also have the added benefit of being able to run e85 or blended ethanol fuel.  Running ethanol is one of the best things you can do for your turbo car, as it has a higher octane rating and is less prone to knock than 91/93 pump gas, and you have the potential to make more power as a result. We offer tuning support for Cobb, HP Tuners and SCT software.Gain more injector headroom - add on a Nostrum upgraded fuel rail sensor! The factory fuel rail sensor is incapable of reading pressures beyond 20MPa, thus it is necessary to replace the factory sensor with the Nostrum Fuel Rail Pressure Sensor in order to take full advantage of the Nostrum Standard Bore Plus high pressure fuel pump, which is capable of operating at pressures up to 24MPa (240 Bar, or 3480 psi). Going from 200 to 240 Bar results in an additional 10% increase in injector flow!Complete your fuel system upgrades by bundling in a set of our High Flow Ecoboost injectors! These are the same great injectors that are already proven and making power on the Focus RS and Ecoboost Mustang platforms! Flowing 36% more than the stock Focus ST injector, our High Flow injectors give you more than enough headroom for whatever your power level goals are!Nostrum backs every part we sell with a limited lifetime warranty. All Nostrum products come complete with everything you need inside the box, including detailed installation instructions. Tuning guides are also available for your dealer or tuner. We have customer service and calibration engineers on staff to provide you with any support that you may need, from installation to tuning. What comes in the box:1050-250 High Pressure Fuel Pump - fully welded, stainless steel construction  Pump mounting flange  Installation hardware  Flange alignment tool Protective caps  Install Guide provided in print Vehicle applications:(15-18) Ford Focus ST*(2013 & 14 Focus ST still pending calibration validation)